Tap Repairs in Taigum
Ninety times in a hundred the dripping tap has one small worn part inside, not a dead fixture, so tap repairs in Taigum are bread-and-butter work for our team. Washers, jumper valves, ceramic cartridges, O-rings and spindles all get handled by a licensed plumber. We work across Taigum and the neighbouring suburbs sorting them out.
If we're late, $100 comes off your bill
- Licensed and InsuredEvery job done by a licensed plumber. QBCC No: 15024607
- Fixed Quote FirstFlat-rate pricing, agreed before any work starts
- Lifetime Labour WarrantyBacked by our Fix-It-or-It's-Free guarantee (T&Cs apply)
- $0 Call-Out FeesNo extra charge for nights, weekends or public holidays
Two things decide how a repair runs: the type of tap on your bench, and whether the fault shows at the spout, the handle or the base. This page covers both, plus where the law draws the line on do-it-yourself work and when a tap has reached the end of its life. For the wider fixture list, see our tap and toilet work page.
Which Part Fails in Your Tap
Two tap types sit on Taigum benches, and each one closes the water with a different part. A washer tap drives a rubber washer down onto a machined seat. A mixer turns a ceramic cartridge a quarter turn.
Washer taps
You spot them by the two handles, hot and cold, each turning several full rotations. A jumper valve is the small carrier at the bottom of the spindle that presses the washer home. Either the washer or the valve can wear.
Mixer taps
One lever controls both temperatures, and the sealing happens inside the cartridge. When the ceramic cartridge wears out, the entire unit comes out and a new one goes in, matched to the make and model, because sizes and fittings differ between brands.
A handle that has gone stiff or gritty, even while the tap still holds water, usually points to wear inside the cartridge or the spindle rather than a leak you can see yet.
Tap Repairs for Owners and Tenants
The QBCC draws a narrow line around what a home owner may do without a licence. A tap's jumper valve or washer sits inside that line: anyone with the knowledge and skill the job calls for may swap one, provided the finished work still complies with the standards. Everything past that point is licensed work for a plumber, including a cartridge, a spindle, a reseat, or fitting a whole new tap.
Renters have a simpler job. Tell the owner or property manager as soon as the drip appears, because a repair the Act does not class as an emergency counts as routine, and they must arrange it within a reasonable time. If nothing happens, a Form 11 notice gives them seven days to fix it.
Still Dripping After You Turn It Off
A drip from the spout while the tap is fully closed tells you the closing part has worn: the washer or its seat on a washer tap, the cartridge on a mixer. Where the water shows up is the fastest diagnosis there is, because each position points to its own parts.
Water around the handle or the top of the spindle
a worn O-ring or spindle seal, which shows itself while the tap is running.
Water at the base or under the bench
perished O-rings, a loose connection below, or a cracked body.
Nothing at the tap but a drip somewhere else
check the flexi hose and the connections behind the fixture before assuming the tap itself is at fault.
If the tap has no isolation valve of its own, shut the water at the meter's stop tap, turned clockwise. Check first that nothing downstream relies on the supply, the hot water unit especially, before you close the meter tap.
When an Old Tap Is Past Repair in Taigum
The price of a tap repair turns on the tap type, the part it needs, and any damage to the seat or body. Whether the water can be isolated at the tap itself, and how many taps we do in one visit, round out the figure. You see it as a fixed quote once the tap has been opened and checked, not before.
Some taps have earned their retirement. A body that is cracked or eaten away by corrosion points that way, as does a seat too far gone to machine back true. A leak that survives new washers and a fresh cartridge says the same, and a new tap is the better spend.
The suburb's own numbers explain why worn fittings dominate the work here. Area-level figures put population growth at 8.6 per cent across the five years to 2025, against only 6 dwellings approved in 2021-22. The same bathrooms are therefore carrying more people and more turns of the tap each day.
Fittings near landmarks like Fernwood Place Park simply rack up wear faster through sheer daily use. Townhouse rows built to one specification tend to fail in a run, so one dripping basin in a complex often has neighbours next on the list. When the pan or cistern is the culprit instead, our toilet repairs page covers the valves and seals on that side of the bathroom.
How the Visit Runs
- 1
Get in touch
Call (07) 3523 7121 or send a quick message about the job in Taigum, and we'll ask what we need to know.
- 2
We open the tap and test the parts
We isolate the water, strip the fixture on your bench, and check the washer, cartridge, O-rings and seat for wear, matching the fault before any parts are ordered.
- 3
Sign off the quote
You'll see a fixed quote before any work starts, with flat-rate pricing and no hidden fees. The job starts when you're happy with it.
- 4
Pay once it's done
Pay by card or EFTPOS on site after the work's finished, or choose Fix now, pay later.
Plumbing job in Taigum?
$0 call-out fees, available 24/7, and same-day where we can.
Tap Repair Questions
Call (07) 3523 7121Why is my tap still dripping when I turn it off?
The part that closes the water has worn out. On a tap with a washer, that points to the washer itself or a scored seat; on a mixer, the ceramic cartridge has had it. A scored seat chews through new washers, so both need checking before the job is signed off.
What makes a mixer tap leak from the base?
Worn O-rings, a connection under the bench that has worked loose, or a body cracked through corrosion. Water pooling at the base while the tap runs usually points to the first two. A crack in the body means the whole tap has to come off and be replaced.
Is replacing a ceramic cartridge a licensed job in Taigum?
Yes, because a cartridge is not named on the QBCC's short list of unregulated jobs. The swap counts as minor work a QBCC licensee performs, without a permit or a Form 4, and you see a fixed quote before the work starts.
Is it worth repairing an old tap in Taigum?
Yes, when the body is sound and the fault is a worn washer, O-ring or cartridge. A body eaten away by rust, or a leak that carries on after new parts go in, points to a replacement instead.
How many litres can a dripping tap waste?
A slow drip can run through thousands of litres over a year, and that loss lands on your water bill. The utility's concealed leak adjustment does not cover water lost through a dripping fitting, so the repair pays for itself in saved water.
Ring Us About That Dripping TapWe'll call you back.
Ring (07) 3523 7121 and tell us what's wrong. You get $0 call-out fees, a fixed quote before any work starts and same-day where we can, 7 days a week.
To claim your $0 call-out fee, call (07) 3523 7121 today.